+91 (992) 427 0054

Certification
Products

Products

Products / Threaded Inserts For Plastics / Press-In Threaded Inserts



  • Press-in Threaded Series inserts provide adequate holding strengths without the use of ultrasonic or heat equipment. These inserts are most commonly used in thermoset or other hard plastics. The pilot end provides for fast alignment. The insert is placed in a hole, pressure is applied and the three bands of helical knurls dig down deep and lock the insert in place.

  • Press-in Threaded Inserts are available in below design for their Unique Performance

    • Headed Press-in Threaded Inserts
    • Unheaded Press-in Threaded Inserts
    • Reverse Slot Press-in Inserts
    • Flanged Headed Press-in Inserts
    • Straight Knurled Press-in Threaded Inserts
    • Thru-Threaded Press-in Inserts
    • Press-in Threaded Studs
    • Press-in Headed Threaded Studs

  • High pull–out resistance, Self–aligning design, Sharp helical knurls broach into thermoset materials to provide high torque–out resistance.


  • Material : Brass

    Finish : Self/Natural Brass or as per customized requirement

    Available : In a wide variety of thread sizes, stud lengths and options.

    Applications


    Threaded Inserts for Plastics, Threaded Inserts for Thermosetting Plastics, Threaded Inserts for Thermoplastics, Threaded Inserts for Injection Moulding, Threaded Inserts for Sheet Metals. Threaded Inserts for Woods, Timber, Plywood & Laminates, Threaded Inserts for Fibreglass, Threaded Inserts for Epoxy & Rubber, Threaded Inserts for PCBs, Custom Inserts for various Fastening Solutions.

    Material :
    Our Threaded Inserts are available in Brass, Stainless Steel, Carbon Steel, Aluminium & Silicon Bronze material as per Fastening Applications.

    Contact


    WORKS & HEAD OFFICE
    Plot No. E - 17 & 18,
    G.I.D.C. - II, Dared Jamnagar - 361 004,  GUJARAT (INDIA).


      +91-(992) 427 0054
      +91-(288) 273 0876
      info@threadedinsertsforplastics.com
      threadedinsertsforplastics.com